Examples to open and change
Finished drawings made in uCAD. Open one in the editor to look round it, measure it, take it apart or change it — each is built by a short script you can read in the Script panel.
Modern house
Two volumes, the upper one cantilevered over a deck; windows cut into the walls, a pool cut into the site.
Spiral staircase
Fourteen treads turned and raised in a loop, a handrail swept along a helix, a glass balustrade above.
Kitchen
An L of units where every drawer and door is its own object, a worktop with the sink cut in, a hood, an island.
Dining room
Chairs with curved, lofted back legs, a table on splayed legs, places laid for six, a sideboard that opens.
Garden
A pergola over a deck, a gravel path along a curve, a pond cut into the lawn, raised beds, a picket fence.
Desk lamp
A turned base and shade, arms posed with a little trigonometry, coil springs swept along helices.
Toilet
A pan lofted through sections, its bowl cut out by another loft; a lid that lifts, a dual-flush cistern.
Tea set
A teapot turned from one profile, its spout lofted, its handle swept; cups on saucers, a tray.
Spur gear stage
Involute gears from gear(), the gear set to mesh with the pinion, on keyed shafts in bearings, a V-belt pulley.
Flanged pipe joint
Weld-neck flanges turned from one profile, bolt holes drilled in a circle, hex bolts, nuts and a gasket.
Electronics enclosure
A case shown exploded: shelled with round corners, screw bosses, cut-outs, vents, and the board inside.
Draw your own
Start from an empty drawing — no download, no sign-up.